Further development and application of a method for assessing radionuclide surface activity distribution and source location based on measurements of ambient dose equivalent rate.

A method has been developed for solving the Fredholm equation in the barrier geometry for reconstructing the surface activity density (SAD) from the results of measuring the ambient dose equivalent rate (ADER). Inclusion of the barrier geometry means that the method takes into account the shielding effect of buildings and structures on the contaminated site. The method was based on the representation of the industrial site, buildings and radiation fields in the form of a raster and the use of the visibility matrix (VM) of raster cells to describe the barrier geometry. The developed method was applied to a hypothetical industrial site with a size of 200 × 200 conventional units for four types of SAD distribution over the surface of the industrial site: 'fragmentation', 'diffuse', 'uniform' and 'random'. The method of Lorentz curves was applied to estimate the compactness of the distributions of SAD and the ADER for the considered radiation sources. It was shown that the difference between the Lorentz curve for SAD and ADER means that the determination of the spatial distribution of SAD over the industrial site by solving the integral equation is essentially useful for determining the location of radiation source locations on the industrial site. The accuracy of SAD reconstruction depends on the following parameters: resolution (fragmentation) of the raster, the height of the radiation detector above the scanned surface, and the angular aperture of the radiation detector. The measurement of ADER is simpler and quicker than the direct measurement of SAD and its distribution. This represents a significant advantage if SAD distribution needs to be determined in areas with high radiation dose-rate during limited time. The developed method is useful for supporting radiation monitoring and optimizing the remediation of nuclear legacies, as well as during the recovery phase after a major accident.

Further development and application of a method for assessing radionuclide surface activity distribution and source location based on measurements of ambient dose equivalent rate. Examples for Andreeva Bay, Chernobyl NPP and Istiklol.

A method for reconstructing surface activity density (SAD) maps based on the solution of the Fredholm equation has been developed and applied. The construction of SAD maps was carried out for the site of the temporary storage (STS) of spent fuel and radioactive waste (RW) in Andreeva Bay using the results of measuring campaign in 2001-2002 and for the sheltering construction of the solid RW using the results of measurements in 2021. The Fredholm equation was solved in two versions: under conditions of a barrier-free environment and taking into account buildings and structures located on the industrial site of the STS Andreeva Bay. Lorenz curves were generated to assess the compactness of the distributions of SAD and ambient dose equivalent rate (ADER) for the industrial site and the sheltering construction at STS Andreeva Bay, the area of the IV stage uranium tailing site near the city of Istiklol in the Republic of Tajikistan, and for roofs of the Chernobyl nuclear power plant. The nature of impact of the resolution (fragmentation) of the raster, the value of the radius of mutual influence of points (contamination sites), the height of the radiation detector above the scanned surface and the angular aperture of the radiation detector on the accuracy of the SAD reconstruction is shown. The method developed allows more accurate planning of decontamination work when only ADER measurements data is available. The proposed method can be applied to support the process of decontamination of radioactively contaminated territories, in particular during the remediation of the STS Andreeva Bay.